XADO Gel for Diesel Engines is the Best Engine Oil Treatment - Reduces the Need for Engine Overhaul or Rebuild
XADO Gel for Diesel Engines protects engine parts against wear and actually rebuilds ring wear and cylinder wear without expensive engine overhaul or rebuild. XADO Gel forms a new cermet coating on friction surfaces & rebuilds diesel engine to exceed performance level of a new engine - it will extend your diesel engine's life - saves you money from expensive engine overhauls.
One treatment lasts 65,000 miles.
Advantages of XADO:
- repairs and protects against ring wear,cylinder wear and bearing wear
- reduces fuel consumption
-
increases low oil pressure
-
reduces blow by stuck rings
- regains and increases low compression
-
increases engine power, improves acceleration
-
reduces engine carbon deposits
- decreases noise and vibration level
- extends engine life before engine rebuild or engine overhaul
- improves engine operation in as little as 100 miles
Technical characteristics
General characteristics of the cermet layer:
- Microhardness – 750 kg/mm2
- Highly corrosion resistant
- Roughness Ra up to 0,06 mkm
Application:
Treatment of an engine with oil capacity of 3 to 10 quarts:
Step 1
Squeeze out the contents of one tube into the oil of a warmed up engine. Be careful not to drop the XADO tube into the crankcase)
Start the engine and let it idle for 5-10 minutes.
Step 2
Repeat with a second tube of XADO after about 100 miles of normal operation.
Step 3
Repeat with a third tube of XADO after about 100 miles of normal operation. After at least 800 more miles perform oil change and engine service as normal.
Dosage:
3 - 10 quarts oil capacity:
3 tubes of XADO for total treatment: 1+1+1
New engines: 2 tubes
11-20 quarts oil capacity:
6 tubes of XADO for total treatment: 2+2+2
New engines: 4 tubes of XADO
21 - 30 quarts oil capacity:
9 tubes of XADO for total treatment: 3+3+3
New engines: 6 tubes of XADO
31 - 40 quarts oil capacity:
12 tubes of XADO for total treatment: 4+4+4
New engines: 8 tubes of XADO
Allow at least 1,000 total miles operation before changing oil.
Revitalization is considered to be completed after 1000 miles.
Treatment can be done by idling 4 hours per stage. New engines should be treated in one step using 2 tubes at one time.
The protective cermet coating forms on any working metal surface. In case of severe wear, worn parts must be replaced.
